Fixing Spray is a special cosmetic preparation for application over make-up. It creates an invisible protective film, which prolongs the life of the make-up and its effects. Fixing Spray is particularly effective for body painting with Aquacolor and with other wet make-up preparations.
The 24 Color Rubber Mask Grease Paint (RMGP) Palette comes in KRYOLAN’s traditional palette case and contains KRYOLAN’s top quality RMGP make-up. These traditional palette cases, made of thin metal, are popular among professionals because they are highly resistant to breaking, practical to use, and easy to refill. (80 ml 2.8 oz)
An a acrylic tube containing menthol crystals. When using hold the tube a couple of inches away from the performer’s eye and blow through gently. The menthol vapors will cause the performers eyes to naturally tear.
Transparent Jelly is a transparent, greenish-tinted gel for simulation of wet and sweat effects. Dab Transparent Jelly with a sponge or brush onto the required areas of skin, after make-up has been applied and has been set. After a few minutes, the preparation will be almost dry.
Wax Ice spray achieves special effects on skin and hair, which is used in particular in film and television but also casualty simulations. Wax Ice spray gives skin the typical gloss of injuries such as severe swelling or frostbite. When sprayed on hair you can achieve a realistic frost effect in seconds. Wax Ice spray crystallizes in a few seconds in the desired effect. To remove from hair use with warm water and shampoo. Remove when applied to the skin with soap and water.
A lightly shimmering blue gel used to simulate frost and ice in beards and moustaches.
Apply wet and dry on the cool setting) with a hair dryer. Removes with soap and water.
Tip: Mix the iridescent blue gel and the clear gel together before application.
Nose Putty is a wax preparation for alterations of the natural nose form. The required amount of Nose Putty is kneaded between the fingers, with coarse preliminary modeling done with the model mounted on a finger knuckle. The fingers must first be moistened with a little water or gel to prevent undesirable adherence of the putty to the fingers. The small, preliminary wax model is then transferred onto the bridge of the nose, and the work is completed in the form of fine modeling. Before applying make-up, the wax part should be dabbed with Sealer.
Artex is ideal for the creation of 3D skin effects such as wounds, scars and burns – and for concealing unwanted skin anomalies. Carefully mix equal parts (1:1) and apply to the skin. You can create the desired effect immediately after application. The curing process begins after 5-6 minutes. Once the plastic substance has dried, create the desired color design. As soon as the product is set changes are no longer possible. The final effect can be made up with any kind of Kryolan’s grease paint or Body Illustration Color. To create a natural complexion mix Flocking into Artex. Apply powder to set.
Collodion is a non flexible clear material ideal for creating realistic bullet holes and a variety of sunken scars. Brush onto skin in thin layers until you get the desired depth. Watch as it pulls the skin in creating a wonderful scar or cut. Let it dry and colour. Avoid using around the eyes.
Blood Powder allows you to realistically simulate the sudden appearance of bloody effects. It should be applied thinly and uniformly to the required, dry section of the actor’s skin. For best results apply using a powder puff or powder brush. When applied dry it is virtually invisible until activated.
Eye blood to be used in the eye area for special effects in film, theatre or Halloween. Do not use in irritated eye or with contact lenses. Do not keep or use longer than one month after first opening.
A non-toxic gelatin capsule containing special blood powder pigment. Safe to use in mouth.
How to use: Bite down on gelatin capsule and the powder will dissolve with the person's saliva. To remove from skin wash with warm soap and water or use a make-up remover.
Kryolan Latex Clear, vulcanized liquid latex with especially low content of ammonia. Available in the following colors: natural colors, dyed in skin color, and special colors. Latex is used to create small latex appliances such as noses, chin parts, bald caps, and the like. It can also be used to simulate old or injured skin.
Silicone Adhesive Strong Bond is a silicone based skin adhesive of extraordinary tackiness. In comparison to Silicone Adhesive Regular Bond, the tackiness is even stronger and will therefore meet the highest expectations. It is activated by pressure only after all solvent has evaporated. Let the adhesive dry completely before placing the prosthetic onto the skin. Press on tightly once you are satisfied with the position. Silicone Adhesive Strong Bond must be removed from skin with the dedicated remover – Silicone Adhesive Remover.
Hydro Spirit Gum (Water Soluble Spirit Gum) is an adhesive for make-up artists, containing no solvent, with water base. Hydro Spirit Gum is effective in adhering objects for short periods of time, and for holding down hair and eyebrows before they are covered with a bald cap or plastic film.
TV Spirit Gum is a make-up artist’s adhesive, especially for adhering hair, beards, and wigs. The special mixture of natural resins of TV Spirit Gum means that, after it dries, it appears more matt and more natural on the skin than does normal Spirit Gum.
Kryolan's Tear Stick is a wax stick in a lipstick mechanism, with an effective content of menthol and camphor extracts. Apply Tear Stick to the skin, about 15 mm under the actor's eye. Warmth from the skin will release the menthol and camphor vapors, which will rise to the eye and cause real tears to form.